Paper Plane Interceptor 2c1f6i

Interceptor

This plane has a central vertical stabilizer on the fuselage that helps produce excellent straight flights. Make sure to complete the final step of the instructions for good performance.

Orient the template with the “UP” arrow at the top of the page. Then, flip the paper over onto its backside, so that you cannot see any of the fold lines.

Pull the top right corner down toward you until fold line 1 is visible and crease along the dotted line. Repeat with the top left corner.

Fold the right side over again and crease along fold line 2. Repeat with the left side.

30

Fold the nose down toward you along fold line 3.

Fold the nose back up and crease along fold line 4.

Fold the tip of the nose back away from you and crease along fold line 5.

Flip the plane over. Fold the right half of the plane over onto the left half along fold line 6. Cut along the dotted line 7 for the vertical stabilizer.

Tuck the flap that was formed by your cut between the two halves of the plane and crease it along fold lines 8.

Flap 31

When you have completed the step above, your plane will look like this.

Fold the wings down along fold lines 8 and the winglets up along fold lines 9. Add wing dihedral by tilting the wings up slightly away from the fuselage. The wings will have a slight “V” shape when viewed from the front.

VERY IMPORTANT: Pull the back tip of the vertical stabilizer up and toward the front of the plane to put a slight upward curve to the trailing edge of the wings. This is to prevent the back edge of the wings from sagging downward. If you do not do this, your plane will nose-dive straight to the ground. After completing this step, you are ready to fly!

32

UP

1

1

5

4 3 2

2

6

8

9

7

7

8

9