Alarm System Scantronic 9452 603v4y

Scantronic 9452/9453 Instructions Back to Index

Full set the system 1. 2. 3.

Press [1] Press [ENT] Enter [ code]

Exit tone sounds

Part set the system 1. 2. 3.

Press [2] Press [ENT] Enter [ code]

Exit tone sounds

Unset the system 1.

Enter [ code]

Entry tone stops

Reset system after alarm condition 1.

Enter [ code]

Omit a zone 1. 2. 3. 4.

As full or part set plus Press [OMIT] Press [Zone number to omit] Repeat above two steps as required for addition zones

Exit tone sounds Zone is omitted

Change your own code 1. 2. 3. 4.

Press [4] Enter existing [ code] Enter existing [ code] again Enter new [ code]

Two beeps sound Two beeps sound

Test the alarm sounders 1. 2. 3.

Press [8] Press [ENT] Enter [ code]

Sounders should sound

Walk test the detection devices 1. 2. 3.

Press [9] Press [ENT] Enter [ code]

4.

Press [ENT] to end test

Walk test detectors as required - sounder tone changes to indicate detector active

View the event log 1. 2. 3.

Press [5] Press [ENT] Enter [ code]

4.

Press [1] for earlier events and [3] for later event Back to Index